Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
01/20/09 09:19
Read: times


 
#161627 - AT command: OK!!!!
Responding to: ???'s previous message
Good day
thank's to you

for Jeckson
I have used terminal them to Bray version 1.9b optimal suggestion.

for Jan
I have tried to send through terminal a message with commandos AT with
full success.

Now I'am ready to create a program that pressing on the keyboard connected
to microcontroller that it sends a message.

Which passages are necessary?
I try to list them:
to set the transmission speed,
I use a quartz to 12.00Mhz on my board, in the tests with commandos AT I was set up to the
19200 and other parameters then to write commando AT on the serial.
Is possible read the result of a sent command the cellular?, to verify if the result is positive.

But it is better than I attend your councils.

LuigI

List of 8 messages in thread
TopicAuthorDate
Send SMS from cellular telephone S25            01/01/70 00:00      
   step by step            01/01/70 00:00      
      The trouble with using a phone            01/01/70 00:00      
      SMS from Pc            01/01/70 00:00      
         Must used F-bus protocol            01/01/70 00:00      
            AT command: OK!!!!            01/01/70 00:00      
               Manual Time - AT responses            01/01/70 00:00      
                  AT Commands and SMS            01/01/70 00:00      

Back to Subject List